Page 1 of 1
Fitting a note acceptor
Posted: Sat Jan 16, 2016 8:28 pm
by chris_newton
Hi all
Anyone have any idea how much it would cost to get a note acceptor supplied and fitted to a barcrest pacman power up fruit machine, it's already for the facia for it at the front and the box is there inside with wires etc.
Chris
Posted: Sat Jan 16, 2016 10:20 pm
by buzzer
where are you?
mpu5 or 6?
can u post a pic of the wirring loom?
Posted: Sun Jan 17, 2016 9:26 am
by chris_newton
buzzer wrote:where are you?
mpu5 or 6?
can u post a pic of the wirring loom?
It's an mpu6 and I'm In teesside.. Do you still want me to post pics?
Posted: Sun Jan 17, 2016 12:50 pm
by buzzer
too far for me, if i knew what bits you had i could tell you what to you need and talk you through the process
Posted: Sun Jan 17, 2016 12:51 pm
by chris_newton
Ok here are a couple of pictures, hope this helps!
Posted: Sun Jan 17, 2016 2:43 pm
by buzzer
that box is for a note recycler unit, but the cables are not there.
the red and white wire is a 12v supply for led lamp that sits behind the "insert notes here" badge.
recyclers are a right pain in the arse, you would need a full kit for a jsm note acceptor and wiring loom.
would be expensive and not that easy to do if you are inexperienced (no offence inteneded) working on fruities....
Posted: Sun Jan 17, 2016 2:48 pm
by chris_newton
buzzer wrote:that box is for a note recycler unit, but the cables are not there.
the red and white wire is a 12v supply for led lamp that sits behind the "insert notes here" badge.
recyclers are a right pain in the arse, you would need a full kit for a jsm note acceptor and wiring loom.
would be expensive and not that easy to do if you are inexperienced (no offence inteneded) working on fruities....
None taken mate I know I would not be able to do it. So how much roughly would you say it would cost to do it?
Posted: Sun Jan 17, 2016 7:54 pm
by buzzer
dificult to give a set price as manufacuters do not sell parts to the general public, you need an operators license before theses company's will even talk to you...
if i was supplying the parts and installation i would be looking for £100 minimum...
Posted: Sun Jan 17, 2016 7:59 pm
by chris_newton
buzzer wrote:dificult to give a set price as manufacuters do not sell parts to the general public, you need an operators license before theses company's will even talk to you...
if i was supplying the parts and installation i would be looking for £100 minimum...
I'd happily pay that
Posted: Fri Jan 22, 2016 7:18 pm
by DREW
There's a place in Stockton that could help, one of the guys sells on eBay...
Posted: Sat Jan 23, 2016 12:14 pm
by chris_newton
Thanks I'll try them