Payout connector on mpu5

Got a broken machine? Need help? Ask here!
Locked
ta-2d
Junior Member
Posts: 22
Joined: Mon Dec 20, 2010 9:37 pm

Payout connector on mpu5

Post by ta-2d »

Hi Hoping someone would be kind enough to help here, my Barcrest "Can u dig it" machine has started alarming saying error 84-80 hopper missing. Ive replaced the hopper and then the power supply, tried a new coin mech and then another mpu5 board still alarming. I traced the hopper wire back to a white connector than has 14 pins and goes into the payout pins on the mpu5 board. I thought the wire connection was poor and took the single black wire that goes into the connector and cant remember where it goes again. Its either the last or 3rd bottom pin? can anyone help? Im guessing its a standard connector on all mpu5 boards. Or does anyone know why its alarming??

Here is the connector i have the black wire in the 3rd bottom pin (the other wire just loops between pins 1 and 9) im lost here, wish i had left it alone. Now starting to think is the connector in upside down.
ta-2d
Junior Member
Posts: 22
Joined: Mon Dec 20, 2010 9:37 pm

Post by ta-2d »

Ive a photo of this connector but not sure how to post a pic on here?
buzzer
Senior Member
Posts: 592
Joined: Sun Apr 28, 2013 9:58 am

Post by buzzer »

upload it it to tinypic then post the link
Locked