wiring diagram for coin mechanism on Bell fruit machine
Posted: Thu Jun 05, 2014 9:36 pm
looking for some help on wiring up please.
Fruit Machine Chat
Fruit Machine Chat board. 1000's of members swapping hints, cheats and experiences of pub fruit machines and quiz machines
http://www.fruitchat.co.uk/
wiring diagram for coin mechanism on Bell fruit machine
Page 1 of 1
Posted: Fri Jun 06, 2014 10:47 am
Serial or Parallel?
Posted: Fri Jun 06, 2014 7:39 pm
Hi i am new to this all the wiring has been pulled out and some is missing coin mechanism is coin only no tokens.
Posted: Sat Jun 07, 2014 12:26 pm
take a photo and post it 
Posted: Sat Jun 07, 2014 9:33 pm
this is my coin mech there are no wires to it at the moment all had been pulled out or removed
Posted: Sun Jun 08, 2014 1:24 pm
i suspect that might be the wrong mech for that machine, it is a scorpian 5 machine, they normally use c-c talk mechs.
anyways that mech uses 3 connectors to work.
there should be a long connector which plugs in at the side of the mech, this is the main connector which will go to the board.
it also needs a sorter override plug which is a short plug maybe 6 pins with only one or two wires , this diverts the pound coins to cashbox when hopper is full.
and a routing plug whiuch tells the mech where to put the coins.
if its the right mech for the machine all those connectors should be there
anyways that mech uses 3 connectors to work.
there should be a long connector which plugs in at the side of the mech, this is the main connector which will go to the board.
it also needs a sorter override plug which is a short plug maybe 6 pins with only one or two wires , this diverts the pound coins to cashbox when hopper is full.
and a routing plug whiuch tells the mech where to put the coins.
if its the right mech for the machine all those connectors should be there
Posted: Sun Jun 08, 2014 6:02 pm
Thanks for this information, so this coin mechanism wont work with this machine,buzzer wrote:i suspect that might be the wrong mech for that machine, it is a scorpian 5 machine, they normally use c-c talk mechs.
anyways that mech uses 3 connectors to work.
there should be a long connector which plugs in at the side of the mech, this is the main connector which will go to the board.
it also needs a sorter override plug which is a short plug maybe 6 pins with only one or two wires , this diverts the pound coins to cashbox when hopper is full.
and a routing plug whiuch tells the mech where to put the coins.
if its the right mech for the machine all those connectors should be there
Posted: Sun Jun 08, 2014 6:06 pm
i cant tell for sure from the photo you posted, but i doubt it...
Posted: Sun Jun 08, 2014 6:23 pm
I will post a picture of the one i got with the machine,looks like another item to add to my shopping list, do you know where i could get a scorpion 5 manual from.
Posted: Sun Jun 08, 2014 7:27 pm
Have just seen scorpion 4 sticker on coin mech you were right thanks.sgc wrote:I will post a picture of the one i got with the machine,looks like another item to add to my shopping list, do you know where i could get a scorpion 5 manual from.