MPU5 NV7 loom

AndyT · Post by **AndyT** » Fri Apr 12, 2013 6:51 pm

Hi All,
Thanks for reading my post.
I have two NV7 I am looking to fit them to my ClubTropicana and Devil of a Deal.I have no looms.or manuals for them.Ebay have no looms for auction.so can anyone give me the pin connections on the MPU5 to the NV7 pins(I have the operation and pin out manual for the NV7).I have single jumper connectors to link the Note Acceptors to the machine to make my own loom.I have no manual for the machines so I don't know the dip settings once I have done this.Sounds like I don't know much really.But I did use one of the note acceptors and a coin mech in the past for a change machine I built from scratch using a £1 hopper and a 10p hopper and a PIC chip using the NV7 in parallel pulse mode.This was because I needed a token dispenser for a Pachislo machines to exchange cash for tokens that they ran on.Now I have sold the pachislo machines,I want to fit the note acceptors into the fruit machines.
Thanks for Any help
Andy....

marty200868 · Post by **marty200868** » Fri Apr 12, 2013 10:18 pm

There is a guy on eBay that's selling looms for nv8 nv10 an jcm not sure if the looms
Will fit ur board but U can ask
Will send item number he might make 1 for urs

marty200868 · Post by **marty200868** » Fri Apr 12, 2013 10:22 pm

Item number for eBay 330903678796

AndyT · Post by **AndyT** » Sat Apr 13, 2013 5:48 pm

Thanks Marty ,I Have contacted the person on ebay,looking forward to his reply.

AndyT · Post by **AndyT** » Fri Apr 19, 2013 8:06 am

Got a reply back from seller on ebay "These are for scorp 4not mpu 5 but I do not think any will work with nv7 as nv7 were stackers and only used in casino style machines. Yours does plug in to one labelled vend bus and you will have a white connector with nothing on the other end"

So not sure if I am reading this right. but I think he is saying his looms won't fit my machines.I think the NV7 will fit a correct loom for mp5.but because the NV7's are stackers they won't fit in the machine.Can anyone guide me to what I am going what stacker will fit the machine and what loom if any I need.

marty200868 · Post by **marty200868** » Fri Apr 19, 2013 10:25 am

hi andy have you tried the other site

http://www.arcademachinehelp.co.uk/index.php

AndyT · Post by **AndyT** » Fri Apr 19, 2013 6:22 pm

Registered with them this morning.what a pain that was with the squiggly letter and test questions.Managed to get that bit done but have not had a email to confirm i have registered.I Hope I can,It looks like there are downloads for manuals,so I might figure out how to build my own NV7 loom.