Warped machine (Hopper)

paulblackett · Post by **paulblackett** » Wed Sep 19, 2012 11:05 am

Hi, i have a warped fruit machine (global) ive mainly played this machine on free play, now ive decided to use it to save a bit money, but the machine dosnt reconize the hopper. when machine is powered up, it comes up with hopper??? in the display, all connections seem to be intact. tried stripping the hopper and cleaning the sensors. is there pin switchs or something i need to change.

monopolyoftheuk · Post by **monopolyoftheuk** » Wed Sep 19, 2012 11:31 am

I had same issue time back with a billy the quid. I take it it's the onestop tech in a maygay cab with red frame? (also available in a newer BellFruit cab with more reliable tech & gold frame)
Does yours have a note acceptor fitted?
Mine did & would say hopper ??? coin mech ??? and note acc ??? randomly. I discovered it was an error with the CC Talk interface not communicating properly. For me it only happened now n again. So no solution exactly for U. I know U say U have checked all connections .. & seem to be fine - just double check any connection on the coin mech/hopper/notey if there is 1 & main mother board.

paulblackett · Post by **paulblackett** » Wed Sep 19, 2012 2:35 pm

Cheers for reply, it dosnt have a note acceptor, the hopper dsnt work at all so i cant dump the coins if i fill hopper, turn the key dump hopper it does nothing sits there, cant hear it drive. and then says refill 125.00, neither the red button or green button on hopper seem to work. trouble is am not sure wich connector fits into the main board as it seems to go into a harness from the hopper, nightmare to trace all the way bk to board. and if i play the machine and win it says.. i o u........lol

what is the cc talk interface..???

Hopper ??? in display when powering up machine, similar to urs, then goes of then ready to play.

monopolyoftheuk · Post by **monopolyoftheuk** » Mon Sep 24, 2012 2:30 pm

The cc talk is just a name for a system that runs each part into 1 another.. Sounds confusing to me too

I'm racking my brains as to how it was sorted, the only obv bit is that the machine is not picking up the hopper being there at all. & yeh the looms are not str8 forward. I will post again if I have anymore advice for U. In meantime I will check over my onestop board & check connections onto that.