Results 1 to 3 of 3

Thread: Payout connector on mpu5

  1. #1
    Junior Member
    Join Date
    Dec 2010
    Posts
    22

    Payout connector on mpu5

    Hi Hoping someone would be kind enough to help here, my Barcrest "Can u dig it" machine has started alarming saying error 84-80 hopper missing. Ive replaced the hopper and then the power supply, tried a new coin mech and then another mpu5 board still alarming. I traced the hopper wire back to a white connector than has 14 pins and goes into the payout pins on the mpu5 board. I thought the wire connection was poor and took the single black wire that goes into the connector and cant remember where it goes again. Its either the last or 3rd bottom pin? can anyone help? Im guessing its a standard connector on all mpu5 boards. Or does anyone know why its alarming??

    Here is the connector i have the black wire in the 3rd bottom pin (the other wire just loops between pins 1 and 9) im lost here, wish i had left it alone. Now starting to think is the connector in upside down.

  2. #2
    Junior Member
    Join Date
    Dec 2010
    Posts
    22
    Ive a photo of this connector but not sure how to post a pic on here?

  3. #3
    Senior Member
    Join Date
    Apr 2013
    Posts
    592
    upload it it to tinypic then post the link

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •