Fruit Machine Chat

They are 5mm wedge

You probably need the 5mm lamps,these are smaller than the lamps in your buttons,these lamps are wedge lamps and can be wiggled and pulled out,there isn't a lot of ""wiggle " room and you might have to pull out a few lamp holders to get to the lamps you need.

There will be a switch for direct payout or banked. You need to set it to banked

You need someone with a card reader ,i don't know who would have the program,or maybe maygays bulletin board if its still up and running,or maybe an operator might have one you could buy.

You could try swapping the flashboard,thet is where the data is, not sure tho if it has all of it on the card.
The trouble with these onestop boards is that they don't have eproms on so you can't see what game is on until you put it in your machine.

The board could have come out of any machine,not everybody writes on what software is installed. If you just plug it in it will come up with the version number and what game is installed,then you will need your flash card and install your game when the machine asks for it. I don't know if you could ...

You have the eclipse board,and the battery is a flat 3volt cell battery and you have to take the cover off to see it, and it is in the top right hand side , it is about the size of a 10p,and it's not like the varta in the picture. The socket for the flash card is only when you want to install new so...

I still subscribe to it,you can phone them on 01204396397 and pay for the magazine, i have just renewed at £79,and i think it is under the title of GB media now,not just coinslot

This is to recoup some of the R and D costs of the machines,and I think they get cheaper the longer you have the machine, JPM said they are not going down this route .This will stop people who buy used machines for home use as bell fruit won't supply dongles for private use,and I would imagine after...

Clean round the area and scrape off some of the green,then I would use a soldering iron and a solder sucker and take all the old solder off around the pin,then you could bridge the gap with link wire,or if the gap is small you can bridge the gap with solder

It's a separate board and is usually fastened to the back of the cabinet below the mpu

Have you not checked the hopper driver board,I think the mpu 4 driver board has some fuses on,could one of them become slack in their holder or has it blown

Normally mux alarms are associated with lamps,but if you are trying a different hopper it could be be a multiplex alarm on your switches,which could be a hopper which is incompatible

There is no reset button ,try checking the connections and pins on the cctalk board,this has a small black plug on and the other end is the chrome plug on the pc,it seems like a bad connection if it was working yesterday,

Noble Org have always been a secretive company , I used to work for them for a few years and they never wanted any publicity ,good or bad,they must be worth a few quid though as they have sold loads of arcades