Fruit Machine Chat

definately up ALOT. but i do get sum unfair advantages, quicker than most,

yeah, sounds like it's just lost 12v from the PSU to the MPU. but need more info. to be sure.

are you sure it's the MPU3 thats faulty? are they all producing the same error?

i think Red has taken the principals for the new non legacy to seriously with there programing.. as they have the half j/p streak right but havn't included the £70 repeats to a £210..

by any chance did you buy this machine off ebay?

as the seller (to comply with ebays rules) will have disconnected the mech and hopper

you don't actually need the key it's self. just short out the wires on the back of the lock

the button you are pressing is your 'top-up button' this should only be pressed when you are filling the hopper. usualy £125 coins if note accepter not fitted. what you need to do to resolve this is either put £125coin in or set the machine to the float you have in it. you can do this by dumping the...

just ensure the wire is being cut into by the metal on the lamp holders on your common wire on the bulbs that are off. just use a small flat head screwdriver, anything will do tho.

is the program card (gamecard) with the software chips in properly. they often come loose. just ensure it is fully pushed in

i think your two black wires should go on either of the outer pins

and white and red on the middle ones

eg.

double black
red
not used

not used
white
single black

your machine is either in demo mode.

the coins are paying out inside the machine, hopper not in correct position

or you have a coin jammed in the optic sensor

if your sure theres nothing in the mech and the machine doesn't count down from 30 seconds the clear. check the note acceptor and hopper aswell

check your 5V pin on the loom to the PSU, make sure it's not coming loose

as when the PSU gets hot it causes the metal on the pin to expand

[quote="&quot"]I'm going to go for the obvious....is the collect button functional? Is the microswitch clicking when you press it?[quote] yeah, just sounds like the collects buttons not working to me. if your not sure just take the two wires off the microswitch, (NOT THE LAMP ON BULB H...

sounds like you've lost 12volts to the mech. or you secondary 12v.

ensure both are there with a multimeter

if not try you £1 inhibit/accept wire.

should be a loom diagram in the machines manual